aisi 1045 properties Related introduction

  1. ASTM SAE AISI 1045 Carbon Steel Heat Treatment, Chemical ...

    SAE AISI 1045 Steel. ASTM SAE AISI 1045 steel is one of the commonly used medium carbon steels with an average carbon content of 0.45%, medium tensile properties, good strength, toughness and wear resistance. It can be treated by annealing, flame treatment or induction hardening.

  2. AISI 1045 - Steel grades, Properties and Global Standards

    AISI 1045 can be supplied as steel plate/ sheet, round steel bar, steel tube/pipe, steel stripe, steel billet, steel ingot, steel wire rods. electroslag, forged ring/ block,etc. Join Supplier: [email protected]

  3. MEDIUM TENSILE STEEL AISI 1045 - S&T Stainless

    TYPICAL MECHANICAL PROPERTIES for guidance only Water or oil quenched at 830C 850C and tempered between 540C 680C. MEDIUM TENSILE STEEL AISI 1045 - continued WELDING: Readily welded as supplied with the correct procedure, but welding when through hardened, flame or induction hardened is not recommended.

  4. What is 1045 / S45C / C45 Steel Properties Chemical ...

    1045 steel is widely used for the industry application that required higher strength and wear resistance than low-carbon steel. And the typical applications are gears, shafts, rolls, crankshafts, sockets, bolts and etc.

  5. 1045 medium tensile carbon steel in AISI Standard

    AISI 1020: AISI 1020 is a low carbon steel which shares features like easy machinability and high weldability with AISI 1045 steel. However it has lower carbon content which makes it less harder and it doesnt support hardening processes either unlike AISI 1045. AISI 1006: AISI 1006 are mild steels which have low hardness and are used in drawing. They are also very machinable and can be welded easily although its hardness is much lower than AISI 1045.

  6. AISI 1045 CARBON STEEL

    AISI 1045 steel is characterized by good weldability, good machinability, and high strength and impact properties in either the normalized or hot rolled condition. AISI 1045 steel has a low through-hardening capability with only sections of size around 60 mm is recommended as suitable for tempering and through-hardening. However, it can be efficiently flame or induction hardened in the normalized or hot rolled condition to obtain surface hardness in the range of Rc 54 - Rc 60 based on aisi 1045 properties

  7. Related searches aisi 1045 properties

    aisi 1045 mechanical properties, aisi 1045 equivalent, astm 1045 steel properties, aisi 1045 chemical composition, mechanical properties of 1045 steel, aisi 1045 properties carbon steel, aisi 1045 steel, aisi 1045 welding, aisi 1045 specification, aisi 1045 yield strength, sae 1045 mechanical properties, aisi 1045,

Online Consultation