steel grade 45 Related introduction

  1. What is grade 45 steel? - Quora

    China 45 steel is a quality medium carbon structural steel, average carbon content is 0.45%, can be used for shaft parts, steel wire ropes, etc. For more info please check: China 45 Steel Equivalent, Mechanical Properties & Chemical Composition * steel grade 45

  2. 45 (GB ) - Worldwide equivalent grades - Steel Number

    45 (China, GB ) - European (EU, EN) and wordwide Steel equivalent grades These comparison table is only intended as an indication of the closest khown equivalent grades. The source standarts should always be checked for the specific purpose for each material, in case of doubt Buy, sell, suppliers search product 45 on-line

  3. GS-45 steel - Steel grades

    Stainless Steel, Special Steel, Compressor Blading, Turbine Blading, Superalloy Supplier. GS-45 can be supplied as steel plate/ sheet, round steel bar, steel tube/pipe, steel stripe, steel billet, steel ingot, steel wire rods. electroslag, forged ring/ block,etc.

  4. 40Cr Steel Equivalent, Mechanical Properties & Chemical ...

    40Cr steel is a kind of Chinese GB standard alloy steel for engineering and machinery purpose, and one of the most widely used steel grades.For 40Cr material hardness, specifications and equivalent, please see the table below. After quenching and tempering treatment, 40Cr steel has good comprehensive mechanical properties, low temperature impact toughness, low notch sensitivity, good steel grade 45

  5. C45 Medium Carbon Steel grade - materialgrades.com

    C45 grade steel is defined as a medium carbon steel offering tensile strengths in the modest range. The material can be maneuvered with hardening by means of quenching and tempering on focused and restricted areas. C45 can also be instigated with induction hardening up to the hardness level of HRC 55.

  6. ASTM A570 Steel, grade 45 - MatWeb.com

    Maximum thickness of 5.8 mm. Hot rolled carbon steel sheet and strip of structural quality in cut lengths and coils. Copper content of 0.20% is a minimum when copper steel is specified. Tensile tests are taken in the longitudinal direction. Similar entries in MatWeb include: ASTM A570 grade 30, grade 33, grade 36, grade 40, grade 50: Key Words:

  7. Related searches steel grade 45

    45 steel properties, steel grade chart pdf, 45 steel equivalent, number 45 carbon steel, steel grades chart, stainless steel grade 45, 45 carbon steel, stainless steel grade, steel grades and uses, steel grade ss400 specification, grades of steel, steel grade s355,

Online Consultation